Hello,
Is there a way to slow a simulation down to a stop? I have this hose with water flowing through it and it gets clogged up and the water needs to come to a halt at a particular time.
A sudden stop doesn't look nice at all! Is there a way to ease into the stoppage over time?
I set the Initial State, so the water is in the tube when the scene starts. I tried animating the speed from 4 to 0, but that doesn't effect the particles already in the tube, just the newly created ones.
I also tried time warping a cached clip, but that freaks the particles out BADLY!!
Any help would be greatly appreciated..
thanks for your time,
-TN
slowing down to a stop??
Re: slowing down to a stop??
hahhhahahah... Got it!!
thanks anyway
thanks anyway
Re: slowing down to a stop??
Hey thorsnuts!
Cool that you got the solution..! It would be nice if you could post the solution, too! So this thread might be helpful for other people having the same problem ;) Thanks!!
cheers,
oli
Cool that you got the solution..! It would be nice if you could post the solution, too! So this thread might be helpful for other people having the same problem ;) Thanks!!
cheers,
oli
Founder of www.si-community.com
http://www.pixelpanic.de
http://www.pixelpanic.de
Re: slowing down to a stop??
hahhaaa your right... wasn't thinking.
I used the Set Particle Speed node, and animated a few values over time.
thanks anyway,
-tn
I used the Set Particle Speed node, and animated a few values over time.
thanks anyway,
-tn
Who is online
Users browsing this forum: No registered users and 15 guests