units and scale issues with Face robot and gear rigs..

General discussion about 3D DCC and other topics
Post Reply
t4d
Posts: 51
Joined: 06 May 2012, 04:26

units and scale issues with Face robot and gear rigs..

Post by t4d » 28 May 2012, 09:04

I understand the .. open unit system of softimage but sometimes it a PAIN !!

OK rigged afew heads in face robot attaching them to gear body rigs.. :(( scale up the body is distorts,. scale down the face it distorts

so thinking i should check the scale that the face robot templates are ... there are at different sizes too ?!?!

OK so what is the solution ? I created my bodies to a cube so all were the same scale to fit into scenes
but my heads are different sizes ( around 20% range of each other )

do i have to re-rig all the heads or is there a better solution ?

Post Reply

Who is online

Users browsing this forum: No registered users and 31 guests