Suddenly the right click doesn't show the modeling menu. It instead select-deselect edges, polygons, etc.
Any idea?
Right click doesn't work anymore
Right click doesn't work anymore
Piero Desopo
http://phoenixart.com
http://phoenixart.com
- Hirazi Blue
- Administrator
- Posts: 5107
- Joined: 04 Jun 2009, 12:15
Re: Right click doesn't work anymore
You've probably switched to the SI|3D Selection Model by mistake... ;)
edit: Make sure "Select > SI|3D Selection Model" (and probably Select > Extended Component Selection") is off.
PS I am not near my SI right now, so I can't check exactly.
edit: Make sure "Select > SI|3D Selection Model" (and probably Select > Extended Component Selection") is off.
PS I am not near my SI right now, so I can't check exactly.
Stay safe, sane & healthy!
Re: Right click doesn't work anymore
Thanks Hirazi blue, that was fast!
Actually the selection model looked like this: But switching back and forth fixed it.
Actually the selection model looked like this: But switching back and forth fixed it.
Piero Desopo
http://phoenixart.com
http://phoenixart.com
Who is online
Users browsing this forum: No registered users and 32 guests